![]() The easiest way to do this is to connect it directly to the USB/Serial converter in the Arduino. Download link for the software is provided at the bottom of this page, below we have the step by step procedure for adding a new fingerprint using this software: 1.įirst up, you'll want to connect the sensor to the computer via a USB-serial converter. Though these have no good English documentation, SFG has done a real good work with the demo software (except the bad UI:P ). Here's the link: GND fingerprint-sensor/downloads. This Code is for SFG Demo rev2.0 from Adafruit. The interface/test software is unfortunately windows-only but you only need to use it once to enroll, to get the fingerprint you want stored in the module. Fargo Build A Badge Software Download Free on this page. ![]() ![]() The easiest way to enroll a new fingerprint is to use the Windows software. Can enroll, match, delete, set config, show and save finger print image. Since we do not have to write code before. Testing for working for Fingerprint scanner module with SFGDemoV2.0, that It works properly or not. Fingerprint Scanner with SFGDemoV2.0 program (Enroll, Match, Capture and Show fingerprint image),it runs on Windows. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |